Industrial Centrifugal Dryer Product Description
If you own an electroplating workshop and looking for a low-cost dryer for your parts, you are in the right place. The Economic Centrifugal spin dryer is a great cost-effective solution for people who don’t need the industrial power to dry their parts. It comes with basic drying and heating functions.
Before you start operating, it’s crucial to check the power connection first. If the machine is properly powered, run the machine for a few minutes before jumping into using it. The machine should heat up and start blowing hot air. If not, check the heating elements installed below.
Make sure that you spread the parts evenly in the machine. Don’t use heat the first time. Let the centrifugal force take away the excess water and other material. Now, you can turn the heat on to dry the parts perfectly.
Keep in mind that you need to remove the power before you hit the brakes. The machine can run the spinners separately but the heating doesn’t work without the spinning.
|Rotation speed||630 rpm||530 rpm|
|Voltage||380V 50HZ 3phase||380V 50HZ 3phase|
- Very cost-effective
- Easy to operate
- Compact design to fit anywhere
- Easy maintenance
- Used for drying small and medium parts
- Used for de-oiling small media